Hi bob,
Thanks for comment, your right Paul T, I think it was September in this photo so probably in the mid 30’s at the time!, minus 1 now!
As this is my first scratch build I have made a few mistakes so far, like forgetting to build the frames higher than the build board, which required a later mod to lift it 100mm clear, and choosing 2mm ply to cover the hull which has been a nightmare to get the forms of the hull correct (especially the nose!). As I could only got marine ply delivered to France in max of 1.2m lengths I’ve also had to splice in the last 200mm, which was not ideal, but after sanding/filling etc you can’t seem to feel the joint.
I’ve just got the 2 props to put in, as I still haven’t sized the motors yet I went for M4 (6mm OD) 350mm shafts so hopefully this will give me a wider choice of propellers etc when I finally choose the motors.
Next step is fibre glassing, however as it does not seem to need the strength I was intending on using a polyester resin with nappy liners as I have a nasty reaction to glass fibres due to being asthmatic!
Any obvious potholes I’m heading into, please shout up!
Thanks
Paul