Radio Interference

Radio Interference

Home Forums R/C & Accessories Radio Interference

  • This topic is empty.
Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #5460
    Tim Cooper
    Participant
      @timcooper90034
      #69418
      Tim Cooper
      Participant
        @timcooper90034

        Do all electric motors in a Model need protecting against radio interference?

        In my latest Model I have the main drive motors protected but I have just started putting in 2 small geared motors to drive the radars. These will sit 12 to 14 " off the deck so far I haven't put an interference kit on them. The radio is a 2.4 ghz system.

        Thanks

        Tim

        #69421
        Dave Milbourn
        Participant
          @davemilbourn48782

          No – certainly not with a 2G4 radio.

          DM

          #69423
          Tim Cooper
          Participant
            @timcooper90034

            Thanks Dave

            Tim

            #69425
            Dodgy Geezer 1
            Participant
              @dodgygeezer1

              You apply RFI suppression to protect your own boat against interference, AND the boats of anyone who is sailing close to you. Some of these might be on 40 MHz, or indeed, 27Mhz, if they are toys…

              However, if these are tiny motors, any radiated interference is likely to be minimal, especially if they are low volt and low load. And I suspect that someone would have to sail quite close with a susceptible boat to be affected. And if they were, once you sailed away they would be OK. And most sets are 2.4GHz nowadays anyway.

              So Dave's advice stands…

              #69426
              Malcolm Frary
              Participant
                @malcolmfrary95515

                Reducing the interference that any brushed motor does generate not only reduces the chance of interfering with other radios, but absorbs the voltage spikes that go with the sparks. Not feeding those into the output of the ESC is usually a good idea.

                Contrary to popular opinion, interference does not just get in via the receiver aerial, any internal wiring is capable of doing the job, so it is good policy at less than a quid a motor to stop it at source.

                #69431
                Dodgy Geezer 1
                Participant
                  @dodgygeezer1
                  Posted by Malcolm Frary on 13/01/2017 18:53:18:

                  Reducing the interference that any brushed motor does generate not only reduces the chance of interfering with other radios, but absorbs the voltage spikes that go with the sparks. Not feeding those into the output of the ESC is usually a good idea.

                  Contrary to popular opinion, interference does not just get in via the receiver aerial, any internal wiring is capable of doing the job, so it is good policy at less than a quid a motor to stop it at source.

                  Ancillary motors are often on a different circuit to the main system – perhaps with different batteries and a relay switch – but your point is perfectly correct for any connection that can put spikes into the ESC. Cheap Chinese ESCs are often very vulnerable to such interference. I would guess that DM's Action electronics is much more robust!

                Viewing 7 posts - 1 through 7 (of 7 total)
                • Please log in to reply to this topic. Registering is free and easy using the links on the menu at the top of this page.

                Code of conduct | Forum Help/FAQs

                Latest Replies

                Home Forums R/C & Accessories Topics

                Viewing 25 topics - 1 through 25 (of 25 total)
                Viewing 25 topics - 1 through 25 (of 25 total)

                View full reply list.