Hi Ashley and all, and nice to see Bob Abel managed to travel down too. Dave W, Telford is an ambition of mine too, shame its the Saturday of the Warwick Show.
Now, reading through this thread I think Ashley has managed to mistake my staysail as a hanky, shame on you sir, and also, the barge stand, AMBO, of which I am also a member and assisted on for part of my time at Warwick, was not the stand that Colin referred to as the winning stand. That was the Manx Model Boat Club stand shown here.
Yes, I think, but stand to be corrected, that there were two Kims present and both of us were actuality attempting to be on two stands at the same time, by that Ashley, two different people called Kim.
My vote for best stand was the official photographer, and only those that saw her know what I mean.

This is the front, from the RH side.

This is the RH side, with stand builder and designer, Jason Fleming powering up Vigilant, a C&E launch.

And this is the LH side and rear. We planned a recess into the rear so that we could present 5 different demonstrations each day, on the 1/2 hour to interact with visitors. A very large digital screen in the side also ran Club slide shows and videos, and was also connected to the camera (in foreground) for filming demonstrations of small items up onto the big screen. The demonstrations were, in order presented each day, ropewalk and ropes; a look inside HMS Chatham; steam engine models; programmable computer chips to control gun turrets and the rowing boat (PICAXE); inside U203 – or how it works!
The basic stand itself was as supplied, Clubs select the table layout from the organisers, ours was 20 x 12 feet. 8 tables side by side at the front, and the recess created by two pairs of two tables longwise each side. A tiered display was then created using folding plastic kitchen steps (about 8 x 8 x 10 inches) and pre cut wood shelving, MDF. The first layer was about 3 foot wide, and the top tier was 10 inches wide. This layout gives a massive layered display area, far greater than flat table tops. Then these are covered with marine themed cloths.
The banners were suspended in a pre-made white plastic pipe rectangle supported upright using 1metre sash clamps on the table top edges. The display recess area had boat boxes supporting demonstration items and under the cloths the stowage areas. A single 2.5 x 6 foot table was the demonstration work top. We also brought over "tensa" barriers with us to finish the job (the red tape). We also brought our own lighting, PAT tested of course.
Over 50 boats, boxed, of which 39 were on display, the others being used for the fun time, swan, ducks, tugs etc. Everything, including table cloths was fitted into two vans. We travelled the Wednesday before the show, and arrived 10am on the Thursday to set up, and did not leave site on the Sunday after the Show till nearly 7pm.
But not to disappoint, and again at the Show here, for Ashley, is the AMBO diorama that Richard Chesney so brilliantly assembled from bits he took and requested from myself and Peter Simmonds, Isle of Wight. I think they say it all.

The barge diorama from the front, and below, from astern……….enjoy………Kimosubby

A long post, but I've tried to anticipate questions, any of which we are happy to answer.
Edited By Kimosubby Shipyards on 11/11/2014 14:53:58